Turn your car stereo on to allow the Toyota antenna to run up. Pull the mast from the power antenna while the motor is still running. Compare the length of the new antenna mast to the old one. If mast lengths match, install nylon cable into the antenna hole and turn the car stereo off. Feed the cable into power antenna motor assembly.
Almost everyone have their own garbage pick up but most of the time they won’t take your old auto parts, maybe because of its heaviness. You still have an option, by placing your old auto parts out of your fence among the rest of your recyclables, so your pick up won’t have any other choice but to take them, if they can obviously. However, if the auto parts remain and not taken by the truck, then something is wrong you have to do something about it. Then take them into your car or whatever means you have, bring it down to the recycling center, but make sure you’ve called the administrator or the manager. Make an appointment, get the schedule on when they are accepting craps like the one you have to find out if that’s the right place to drop off your trash.
Even though there may be plenty of used parts available in your city, you may not know where to look. Used parts shops and recyclers that sell them are popularly known as junk yards, salvage yards, wrecking yards as well as auto recyclers. So all you need to do is search for such places in your locality by using newspapers or the internet.
2) The junk yard. While you might think you are above visiting a junk yard, are you above saving a lot of money? Probably not. A quick stop in at the local junk yard might save you a lot of money compared to a new air filter. And, even better, this ties directly into point #1. A friend of my, Robert, needed an auto part so he looked online and found a custom car part. The junk yard shipped him a part that was almost new and he couldn’t have been happier. Just cause an air filter is used, doesn’t mean it’s very used!
pull parts After this, disconnect the transmission from the engine and this is firstly done by freeing up the bolts connecting these two parts. You will most probably need a socket set for this. Once the bolts are gone, lower the transmission on to the jack and then on to the floor.
There are many things that you should think about when you are looking for the parts for your race car. You have to think about the quality as well as the way that you will get the parts to go with you when you are going to the races.